Unraid Reset Network Settings Install _top_ < GENUINE ◉ >

If you prefer the standard command line, boot normally and log in using the username root and your system password. Step 2: Use the Terminal to Remove the Files

Remove the network configuration and network rules files by running these commands: rm network.cfg rm network-rules.cfg Use code with caution.

To reset your Unraid network settings to the installation defaults, you generally need to delete or rename specific configuration files on your Unraid boot flash drive unraid reset network settings install

Resetting your network configuration disables custom bridges (like br0 ). If your Docker containers or Virtual Machines were configured with custom IP addresses on your local network, they will fail to start. Go to Settings > Network Settings , enable bridging, and verify your docker/VM network paths match your new layout.

If you have set up custom routing or bonding, you may also see a file named . Delete or rename this file as well. Step 4: Reboot the Unraid Server Safely eject the USB drive from your computer. Plug the USB drive back into your Unraid server. If you prefer the standard command line, boot

This is the most reliable method if you cannot reach the WebGUI at all.

Type the following commands to remove the configuration files: If your Docker containers or Virtual Machines were

Enter the following command: cd /boot/config Use code with caution.

If you have a monitor and keyboard attached to the server, you can reset settings without moving the USB drive. Local GUI Mode : Reboot the server and select Unraid OS GUI Mode

Input your desired static IP address. Ensure this IP is outside of your router's automatic DHCP pool to avoid IP address conflicts with other devices.