Ts1162 Installation Manual Exclusive [top] Jun 2026
, the general physical installation steps for this series of RAS keypads include: support.firesecurityproducts.com.au The unit can be mounted indoors or outdoors.
: Rated IP67 for superior weather and dust resistance.
The TS1162 is not a "plug-and-play" device. Its internal architecture includes a multi-stage gearing mechanism, a proprietary dampening system, and a feedback-loop sensor array that requires micron-level precision. A standard manual tells you what to connect; this exclusive manual tells you why each step matters and how to avoid the six most common installation failures that void warranties and cause downtime.
Separate the body from the base by removing the retaining screws at the bottom. ts1162 installation manual exclusive
Once powered, the TS1162 goes through an internal Power-On Self-Test (POST). Follow these steps to configure the system topology:
Antenna and wireless setup (if applicable)
Remove the body from the base by unscrewing the retaining screws at the bottom. , the general physical installation steps for this
The TS1162 is a highly advanced and versatile device that requires careful installation to ensure optimal performance and safety. As an exclusive user, it is essential to follow the guidelines outlined in this installation manual to guarantee a successful and hassle-free setup. In this article, we will provide a step-by-step guide on how to install the TS1162, highlighting key considerations, technical specifications, and troubleshooting tips.
Keep all power cables (110V/230V) at least 300mm away from the TS1162’s encoder cable. If routing must cross, do so at a perpendicular 90-degree angle. Parallel runs over 50mm will induce crosstalk errors exceeding 12 microsecond jitter—enough to destabilize the TS1162’s feedback loop.
+-----------------------------------------------------------+ | TS1162 REAR INTERFACE | | | | [ FC Port 1 ] [ FC Port 2 ] [ Ethernet ] [ Power ] | | (Primary) (Failover) (Management) (Input) | +-----------------------------------------------------------+ Once powered, the TS1162 goes through an internal
: The TS1162 includes a 2-meter pre-wired LiYY cable. If extending the cable, use a high-quality twisted, shielded pair for the RS-485 data lanes (D+ / D-). Avoid making tight wire loops inside adjacent junction boxes [1.11].
: If using an exit button, connect it to the Request to Exit input.