Pixhawk 248 Firmware !!exclusive!!

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

Use a high-quality micro-USB cable to connect your Pixhawk 2.4.8 to your computer. Do not connect your drone's battery during this process; the USB will provide enough power to flash the board.

Connect the Pixhawk to your PC using a high-quality micro-USB cable. Mission Planner will automatically detect the board. pixhawk 248 firmware

Do you have a story or tuning tip for Pixhawk 248 firmware? Share it in the comments below or join our community forum. For more updates on legacy drone firmware, subscribe to our newsletter.

The original Pixhawk 1 (FMUv2) has only 2MB of flash. Newer firmware (ArduCopter 4.4+) often exceeds this limit or requires stripping features. (e.g., 3.6.11) fits perfectly, leaving room for parameters and logs. This public link is valid for 7 days

Click the "Setup" tab, then select "Install Firmware".

The "248" firmware was the last "golden master" for the original 2MB flash-limited Pixhawk series before ArduPilot moved to the more resource-intensive ChibiOS operating system. Can’t copy the link right now

Go to Flight Data → Status and verify: