Following content is for adults only.
Are you sure you're at least 18 years old?
No
Yes
Onkyo Rc-799m Remote Manual
: The central cluster features Up/Down/Left/Right arrow keys, a central Enter button, Setup , Return , and Home buttons for on-screen menu navigation.
Whether you lost the original paper manual, bought a used receiver without the remote, or simply want to program your universal remote to replace this one, you have come to the right place.
: Within 30 seconds, use the number buttons to enter the 5-digit remote control code for your device's brand .
To switch between these modes, simply press the corresponding button as indicated: onkyo rc-799m remote manual
Press and hold down the button, and simultaneously press the appropriate Remote Mode button (e.g., TV or BD/DVD) for about 3 seconds.
You can program the RC-799M to control secondary components like your television, Blu-ray player, cable box, or media streamer. Follow these steps to input a manufacturer programming code. Step-by-Step Programming Guide
Press and hold the DISPLAY button and the desired REMOTE MODE button (e.g., TV, BD/DVD) simultaneously for about 3 seconds. The remote's indicator light will light up or flash. To switch between these modes, simply press the
The RC-799M can be programmed with remote control codes to operate external devices like Blu-ray players, TVs, and cable boxes. Method A: Entering a Remote Control Code
Ensure there is a clear line of sight between the remote and the infrared (IR) sensor on the front panel of the receiver.
If your remote is behaving erratically or you want to erase all programmed codes and macros, the manual provides a full system reset: Step-by-Step Programming Guide Press and hold the DISPLAY
The Onkyo RC-799M is a relatively simple device, but proper understanding is essential to fully utilize your AV receiver. Many users seek out the manual for various scenarios:
If the remote becomes unresponsive or you want to clear all custom programming, you can perform a hard reset: Press and hold down the button. While holding Receiver , press and hold the Home button. Hold both buttons down for approximately 5 seconds.
Are you experiencing or just wrong commands ?
| Problem | Likely Fix | |---------|-------------| | | Press Receiver first, then power. Check batteries. | | Volume controls TV instead of receiver | You’re in TV mode. Press Receiver again. | | Buttons work but feel sticky | Clean with 91% isopropyl alcohol. Open carefully if needed. | | Learned codes stop working | IR memory full? Clear all learned codes (press and hold Receiver + Enter for 5 sec until flash). | | Codes from manual don’t work | Try auto-search method; sometimes codes vary by revision. |