!new! — Iveco Stralis Rfc Fault Codes Free

If the RFC code disappears, the fault lies in the trailer wiring or the plug socket itself, not the truck's internal RFC module. 3. Verify Voltage and Ground Connections

Turn the ignition key to the position (do not start the engine).

Remove the fuel return line from the pump. Place it in a clear bottle. Crank the engine. If air bubbles appear for more than 5 seconds, you have a suction-side leak. Tighten banjo bolts or replace seals. iveco stralis rfc fault codes free

Short circuit or open circuit on the left rear marker/running light.

General fault in the 7-pin or 15-pin trailer plug supply line. Rear Axle Speed Sensor If the RFC code disappears, the fault lies

Below is a breakdown of the most common RFC fault codes encountered on the IVECO Stralis Euro 3, Euro 5, and Hi-Way (Euro 6) models, along with their translations and likely causes. Code / SPN Affected Component Fault Description / Meaning Typical Root Cause Left Rear Indicator Open circuit or short to ground on left turn signal. Blown bulb, corroded light cluster socket, or broken wire. RFC 02 Right Rear Indicator Open circuit or short to ground on right turn signal. Moisture in light housing or frayed chassis harness. RFC 05 Left Tail Light / Marker Fault in the left side marker or tail position circuit. LED conversion incompatibility or bad ground wire. RFC 06 Right Tail Light / Marker Fault in the right side marker or tail position circuit. Broken wire along the chassis rail. RFC 11 Brake Light Circuit Malfunction in the stop light power supply line. Corroded trailer plug socket or faulty brake switch link. RFC 21 Reverse Light / Alarm Open circuit on reverse lights or backing beeper.

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later. Remove the fuel return line from the pump

Note: This works on Euro 4/5 Stralis AS/AT. Euro 6 models may require software.

On older Stralis models, pressing the diagnostic button on the dashboard will cause the malfunction indicator light to blink. Counting the sequence of flashes gives you the specific fault code digits.

This public link is valid for 7 days and shares a thread, including any personal information you added. This link or copies made by others cannot be deleted. If you share with third parties, their policies apply. Can’t copy the link right now. Try again later.

After fixing the issue (e.g., cleaning a sensor), disconnect the battery for 15 minutes OR use a free app’s "clear DTCs" function. Then drive the truck for 30 minutes to complete a drive cycle.