Harvey Hv3 Water Softener Installation Manual ~upd~ Jun 2026

Follow these steps carefully to integrate the Harvey HV3 into your home's plumbing network. Step 1: Shut Off the Water Supply

Connect the other end of the to your soft water plumbing line. Step 5: Install the Drain and Overflow Lines

🚫 Never connect the regeneration drain directly to waste pipe without an air gap – this can siphon dirty water back into your softener. harvey hv3 water softener installation manual

Avoid areas prone to freezing temperatures or direct, intense sunlight. 🗺️ System Layout & Plumbing Diagram

Before cutting into your plumbing lines, verify that your site matches the operational environment required by the unit. Mechanical & Structural Specs BLOCK SALT SOFTENER INSTALLATION INSTRUCTIONS Follow these steps carefully to integrate the Harvey

Cut out a section of the pipe to accommodate your bypass valve block structure.

Check for any leaks again—water pressure can change when the valve is repositioned, so it's worth double-checking. Avoid areas prone to freezing temperatures or direct,

The Harvey HV3 water softener comes with a 5-year warranty on the tank and a 2-year warranty on the control valve.

Place the HV3 as close to the incoming water main as possible, but the outside tap branch (unless you want softened water for your garden).

: Insert a flat-head screwdriver into the manual override button located under the cover. Press and slowly turn it clockwise by one full circle until it pops back up. Let the unit drain for Add Salt and Water : Put

Once everything is connected, it’s time to start the system.