Be aware that updating firmware might void the warranty, depending on the manufacturer's policy.
: Unlike a standard Windows format, these tools perform a "Full Scan" to verify the physical integrity of the memory chips. VID/PID Adjustment
When using Alcor Micro utilities like UFDisk Repack, users may encounter specific error codes that indicate the state of the hardware:
: Re-flashing the controller if the drive is unrecognized or reports "No Flash in Device". au87101a ufdisk repack
Once the progress bar turns green and shows a success status, before closing out the Alcor software. Plug your drive back into a standard Windows machine to verify that the file system loads correctly and displays its full storage capacity.
If you encounter a specific error code during your repack, tell me the or the Flash ID (FID) of your drive so we can adjust your AlcorMP setup file. Share public link
Replace /dev/sdX with the correct device name (e.g., /dev/sda ) [4†L30-L31]. Be aware that updating firmware might void the
When dealing with any driver or firmware "repack" found online, always exercise extreme caution. These files are not always from the original manufacturer and could be malicious.
: The controller detects a critical error or an exhausted write cycle threshold in the flash memory. It permanently locks itself into raw read-only mode to preserve remaining data, rejecting all OS-level formatting commands.
: Use tools like ChipGenius to confirm the controller is indeed an AU87101. If the VID/PID is non-standard (standard is often 058F\6387 ), mass-production software may not see it. Once the progress bar turns green and shows
Even if a drive uses the AU87101A controller, the tool must also support the specific NAND flash chip (Samsung, Toshiba, Hynix, etc.) inside the casing. 🔍 How to Use These Tools Safely
Select standard options for and Optimize Capacity .
