Ensure both units are on the same channel (01–99).
Set to 00:00:00 (let your camera control the shutter speed, e.g., 1/125s). Set INTVL to 00:00:05 (takes a photo every 5 seconds). Set N to 300 (captures 300 photos total). Press the START/STOP button. How to Shoot Long-Exposure Astrophotography Set your camera to Bulb Mode (B) .
– I can guide you to search for a legitimate copy (e.g., on the manufacturer’s website, product listing on AliExpress or Amazon, or by contacting Aodelan directly). aodelan wtr2 user manual
- 6.1 Single Shot Mode - 6.2 Continuous Shooting (Hold mode) - 6.3 Time-Lapse Photography (Interval + N) - 6.4 Long Exposure (Bulb) Timelapse (DELAY + LONG + INTVL) - 6.5 Long Exposure with Noise Reduction (Camera-side setting)
The WTR2 features five primary timer programming modes displayed at the top of the transmitter screen. Press the or RIGHT arrow keys to cycle through them. Press SET to change values, use arrows to adjust, and press SET again to lock the value. DELAY (Self-Timer) Sets the time delay before the first shot is taken. Range: 0 seconds to 99 hours, 59 minutes, 59 seconds. LONG (Exposure Time) Sets the duration of the exposure. Ensure both units are on the same channel (01–99)
Plug the other end into your camera's dedicated remote shutter port. Operating Modes Explained
2.5mm port to connect the camera shutter cable. 3. Getting Started: Battery Installation and Setup Follow these steps to safely power and connect your device. Set N to 300 (captures 300 photos total)
The WTR2 uses relay outputs (dry contacts). Do not exceed 5A at 30V DC / 250V AC unless using an external contactor.
